Apr 11, 2023 Leave a message

How to Adjust a Tillotson Carburetor

How to Adjust a Tillotson Carburetor

 

The Tillotson carburetor is used on small engines designed primarily for go-carts. You can adjust the carburetor in just a few minutes. The carburetor uses a low-speed and high-speed set screw that you can adjust fairly easily with just a screwdriver. The high-speed set screw includes a "T" on the end, allowing you to adjust the screw by hand.

 

STEP 1

 

Locate the idle set screw at the very bottom of the Tillotson carburetor. Turn it clockwise with a screwdriver until you completely close it without over-tightening the screw.

 

STEP 2

 

Find the low-speed adjustment screw with the "L" next to it on the carburetor body. Turn the low-speed screw all the way clockwise and back it out counterclockwise one and a half turns.

 

STEP 3

 

Locate the high-speed adjustment screw with the "H" on the body. Turn the high-speed screw all the way clockwise and back it off counterclockwise three-quarters of a turn.

 

STEP 4

 

Start the motor and let it warm up for a few minutes. If the engine is having trouble starting, adjust the low-speed screw just a bit to get it started.

 

STEP 5

 

Turn the low-speed screw until you can hear the motor slow down. Adjust the screw as slow as you can get the engine to run without stalling out.

 

STEP 6

 

Open the carburetor throttle all the way and adjust the high-speed screw as high as it will go while still running smoothly. Turn the high-speed screw back one-eighth and shut off the engine.

Send Inquiry

Home

Phone

E-mail

Inquiry